OS-1X Ozone Switch™
Acts like a thermostat to control ozone generators and alarms based on an
adjustable ozone concentration set-point. Simple and inexpensive.
Features:
- Contractor-friendly installation.
- Operates from easily available 12-24 VDC or from AC
adapters available world-wide.
- Dead band to avoid system chatter.
- Set-point adjustable by the installer but not by the room occupants.
- Can be installed directly on HVAC air ducts.
Typical Applications:
- Control of ozone purifiers
- Ozone overload protection for industrial processing and storage, and air
treatment in public places
- Leakage alarm for water treatment plants, semiconductor manufacturing,
and for bleaching, cleaning, and sterilization processes.
Specifications:
- Range and Accuracy: .03-.1 ppm of ozone. Approximately 20%
Accuracy.
- Response time: Within 10s of seconds of the ozone reaching the
sensor.
- Measurement Principle: Advanced design HMOS (heated metal oxide
semiconductor) sensor.
- Size: 76 × 64 × 42 mm (3 × 2.5 ×
1.625 in).
- Weight: 5oz. (140 grams)
- Power Requirements: 12-24 VDC, 300 mA. AC
adapters available.
- Output control: SPDT non-latching relay. Contacts rated at 5 amps,
250 VAC, or 1/8 HP inductive load.
- Connections: 5 Circuit totally enclosed terminal block for relay
output and DC input. Also, 2.5 mm DC power jack for AC adapter.
- Indicators: Green LED: instrument on. Red LED: set-point
exceeded and relay activated.
- Case: Flame-resistant ABS.
- Not recommended for outdoor use or in presence of output gases.
Product manual PDF file
(27kb) (requires
Adobe Acrobat
™ reader)
